Fire-by-design AWEIS Manuel d'utilisateur télécharger pdf (Page 7)

3. Electrical Connections / Air Mixer Install. In the photo at

right the wires protruding from the AWEIS have been

connected to the two wires from the electrical conduit using

appropriate sized wire nuts.

In addition the fitting in the photo at far right is to be installed

in the outlet of the AWEIS using either Teflon tape or gas

plumbing pipe dope. This fitting is made up of an Air Mixer

(brass), ½” Stainless Steel coupling and a ½” close nipple.

4. On the side of the AWEIS there are two connections for the Pilot

Burner Assembly as shown in the photo at right. The white ‘quick

connect’ is the electrical connection and the brass plumbing fitting is

the gas connection. There is a label next to these connections,

“Attach Pilot Burner Here”.

5. The photo at right shows the AWEIS after the Pilot Burner

Assembly has been connected.

NOTE: The electrical connection for the Pilot Burner Assembly is a

shaped connection thereby ensuring it can only be connected the

correct way. On the Pilot Burner Assembly side of the connection

there is a locking clip on the quick connect that will ‘lock’ the

connection in place. Therefore after making the connection lightly

tug on the connection to ensure it is in fact ‘locked’ in place.

6. Install the Heat Deflector Shield. Use the two screws that came

with the heat shield to attach the Pilot Burner to the heat shield.

7. Install Fire Ring using either Teflon tape or gas plumbing pipe

dope. Holes in the Fire Ring MUST FACE UP.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Fire-by-design AWEIS Manuel d'utilisateur Page 7