Fire-by-design AWEIS Manuel d'utilisateur télécharger pdf (Page 6)

7. Install Fire Ring using either Teflon tape or gas plumbing

pipe dope. Holes in the Fire Ring MUST FACE UP.

6. Install the Heat Deflector Shield. Notice the heat shield has

a notch on one side. Position the Pilot Burner in the notch

ONLY when using either a 6” or 18” fire ring. For all other

burner sizes attach the Pilot Burner to the heat shield on the

opposite side of the notch as shown in photo at right. Use the

two screws that came with the heat shield to attach the Pilot

Burner to the heat shield.

1” above ring

Arrow

Installation – Propane

Note: Installation should be done by a qualified service technician that is locally licensed.

1. In the photo at right there is a bowl with a gas riser, electrical

conduit and air line stubbed up inside the bowl. In this photo the

gas riser is centered, the electrical conduit is off center slightly and

the air line is off set center by 5”. It is preferred to stub the gas

riser centered in order to ensure the fire ring is centered in the

bowl once installation is complete.

NOTE: Drainage MUST be provided in the bottom of the bowl.

Drainage can be obtained by making a simple hole as shown at

right or providing a drain line next to the gas and electrical

conduit.

1” Drain

Hole

Gas Stub

Electrical

Conduit

Air Line

(5” Off Center)

2. Apply pipe dope to the gas stub and thread the AWEIS onto

the gas riser as shown in the photo at right.

NOTE: Leak Test – it is highly recommended to perform a gas

leak test at this point in the install. Turn on the gas supply and

then, using a soapy water solution spray the bottom of the

AWEIS where it is connected to the gas line to ensure no leaks

exist.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Fire-by-design AWEIS Manuel d'utilisateur Page 6