Fire-by-design AWEIS Manuel d'utilisateur télécharger pdf (Page 5)

1. In the photo at right there is a bowl with both a gas

riser and an electrical conduit stubbed up inside the

bowl. In this photo the gas riser is centered whereas the

electrical is off center. It is preferred to stub the gas

riser centered in order to ensure the fire ring is centered

in the bowl once installation is complete.

NOTE: Drainage MUST be provided in the bottom of

the bowl. Drainage can be obtained by making a simple

hole as shown at right or providing a drain line next to

the gas and electrical conduit.

2. Apply pipe dope to the gas stub and thread the

AWEIS onto the gas riser as shown in the photo at right.

NOTE: Leak Test – it is highly recommended to

perform a gas leak test at this point in the install. Turn

on the gas supply and then, using a soapy water solution

spray the bottom of the AWEIS where it is connected to

the gas line to ensure no leaks exist.

3. Electrical Connections / Orifice Install. In the photo

at right the wires protruding from the AWEIS have been

connected to the two wires from the electrical conduit

using appropriate sized wire nuts.

In addition a short pipe nipple and the Natural Gas

Orifice (supplied) are installed using either Teflon tape

or gas plumbing pipe dope.

4. On the side of the AWEIS there are two connections

for the Pilot Burner Assembly as shown in the photo at

right. The white ‘quick connect’ is the electrical

connection and the brass plumbing fitting is the gas

connection. There is a label next to these connections,

“Attach Pilot Burner Here”.

5. The photo at right shows the AWEIS after the Pilot

Burner Assembly has been connected.

NOTE: The electrical connection for the Pilot Burner

Assembly is a shaped connection thereby ensuring it can

only be connected the correct way. On the Pilot Burner

Assembly side of the connection there is a locking clip

on the quick connect that will ‘lock’ the connection in

place. Therefore after making the connection lightly tug

on the connection to ensure it is in fact ‘locked’ in place.

1” Drain

Hole

Gas Stub

Electrical

Conduit

Installation – Natural Gas

Note: Installation should be done by a qualified service technician that is locally licensed.

Natural Gas

Orifice

1 2 3 4 5 6 7 8 9 10 11 12 13

Commentaires sur ces manuels

Pas de commentaire

Fire-by-design AWEIS Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Sécurité Fire-by-design AWEIS