Fire-by-design AUTOMATED TIKI TORCH Manuel d'utilisateur télécharger pdf (Page 6)

1” above ring

Arrow

Note: If you are NOT locating the Manual Gas Shutoff ON the Tiki Pole skip to Step 5 below

Step 3

If you are installing the Manual Gas Shutoff on the Tiki

Pole (Option 2 from page 4) first remove the handle

from the Ball Valve and then install the ball valve on the

½” gas riser as shown in the photo at right. The use of

pipe dope or Gas Teflon tape is highly recommended to

prevent a possible gas leak.

Step 4

Once the Manual Gas Shutoff is installed

measure from the center of the Gas Shutoff to

the top of the Black Base Pole. This dimension

we shall refer to as measurement “A”.

Step 5

Temporarily install the longer tiki pole and measure from

the seam between the Base Pole and the top of the long tiki

pole. This dimension we will refer to as measurement “B”.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Fire-by-design AUTOMATED TIKI TORCH Manuel d'utilisateur Page 6