Fire-by-design AUTOMATED TIKI TORCH Manuel d'utilisateur

1 WARNING Improper installation, adjustment, alteration, service or maintenance can cause injury or

10 Operation Fire Feature Start Up 1. Prior to turning appliance on visually inspect fire feature to ensure debris such as

11 Maintenance Prior to Each Use 1. Inspect for debris in Fire Feature – remove debris prior to use Semi-Annually 1. Visually in

12 Troubleshooting I installed the Tiki Torch turned it on and nothing happened When this occurs it is usually due to an electrical wiring / power

2 AVERTISSEMENT Une installation, un ajustement, une modification, une réparation ou un entretien inappro

3 Table of Contents Pilot Burner Assembly LP Air Mixer (LP applications only) Gas and Electrical Require

4 Gas Requirements Fuel Type – Before making gas connections ensure appliance being installed is compatible with the available gas type. Check the

5 Installation of Base Pole Installation Note: Installation should be done by a qualified service tech

6 1” above ring Arrow Note: If you are NOT locating the Manual Gas Shutoff ON the Tiki Pole skip to St

7 B – 1” Step 6 Install ½” gas line to your gas riser (or manual gas shutoff valve) such that the end of

8 Step 9 In the photo at left you are looking at a close up of the bottom of the Tiki Torch Head

9 Daisy Chain Wiring of Tiki Torches When wiring tiki torches in series (aka “Daisy Chain” Wiring) it is important to keep the polarity BETWEEN the